Film method for the explosion-proof film: from measurement to paving, details determine success or failure
Speaking of glass film, many people think it is very simple: "Isn't it just a layer film? Is it better to tear it open on the glass?" In fact, the glass film is a "technical activity", actually it is much better than us. It is much more complicated to see.
The application of explosion-proof film usually requires professional tool assistance and attention to various details during the filming process. Before the glass is filmed, first check the integrity of the glass. When the glass is manufactured and transported, the glass is easily damaged twice. Therefore, it is necessary to check whether the glass is intact and there are no cracks or bumps before the film is applied. After recording these questions, be careful when posting, and anticipate problems that may arise. After the basic condition of the glass is determined, it is necessary to measure the size of the glass to be filmed, whether it is square, polygonal or curved glass, and the size should be recorded, and a 1 cm explosion-proof film should be reserved when the film is applied.
explosion-proof film Then it is the calculation and cutting of the material that starts the explosion-proof film. Calculating the number of consumables of the explosion-proof film material before cutting the film helps to reduce the number of consumables and reduce costs as much as possible. Unregulated cutting methods tend to cause consumables to remain and increase the cost of the company's products. After calculating the metrics, it is officially beginning to cut. When cutting the explosion-proof film, pay attention to the scale and use the ruler to make the correct cutting. If the film is taken by visual inspection, errors often occur, which is easy to cause waste, and the edges are not flat when cutting, which is not convenient for the filming process. Therefore, when cutting, you should put the explosion-proof film flat, and do not seek fast, but seek accuracy and harmony. After the cutting is completed, the film is rolled up in a large circle and the mark is marked for standby.
explosion-proof film After that, it is a film. The glass should be cleaned before the film is applied. If necessary, it can be done in a cleanroom to prevent dust or particles from being mixed in the cleaned glass during the filming process. When the explosion-proof film is posted, tear off the protective layer on the surface, sprinkle water between the membrane and the glass, and after positioning the explosion-proof film on the glass, use the corresponding tool to remove excess bubbles and moisture between the explosion-proof film and the glass. Push down the water in the middle of the glass, especially in the middle of the film, pay attention to the completion of moisture and bubble extrusion, and then cut off the extra part with a utility knife to modify the edge of the film.
The posting of the explosion-proof film seems to be very simple, but in fact, it is not easy to do a meticulous thing. The sense of security comes from the details, and the details determine whether it is good or bad.
020-22196485 
sale@ou-home.com
